Custom Black Standing Seam Chimney Cap Install in Wilsonville OR

Most chimney caps you see are generic, off-the-shelf pieces that sort of fit - but not quite. They gap, they rust, and honestly they just look cheap on an otherwise nice home. This Wilsonville job was a different story. The homeowner needed something built specifically for their chimney, and that's exactly what we delivered.

We fabricated this cap entirely in our shop in Boring, OR. Every measurement was taken on-site so the fit would be exact - no shimming, no gaps, no guesswork. The standing seam style gives the cap that clean, modern look with raised seams running from the base up to the flat top. It's a detail that makes a real difference in how the finished product looks from the ground.

The black finish works perfectly against the white painted brick on this chimney. It's a sharp contrast that actually adds to the curb appeal rather than just blending in and disappearing. The mesh ventilation band around the lower section keeps birds and debris out while still allowing proper airflow - which matters more than most people realize for chimney performance.

We do everything in-house - fabrication, fitting, and installation. That means there's one crew responsible for the whole job, start to finish. No hand-offs, no miscommunication between a fabricator and a separate installer. What gets built in the shop is built to fit what we measured in the field. That's how you get a result like this.

The Pacific Northwest is hard on exterior metalwork. Rain, moss, temperature swings - it adds up fast. A cap that's built right and finished properly is going to hold up to all of it. This one is.