Custom Flashing Fabricated In-Shop to Exact Specs

Most flashing issues we see aren't caused by bad installation - they're caused by flashing that never fit right in the first place. Generic stock pieces get forced into place, gaps get caulked over, and a few seasons later you're dealing with leaks that could have been avoided entirely. That's exactly why we fabricate custom flashing in-house.

Here's a fresh batch we just finished up in the shop. Multiple pieces, clean bends throughout, tight seams on every profile. Each one was built to exact specs before it ever gets near a roof. When flashing is made to fit the actual geometry of your building, it goes on clean and stays sealed the way it's supposed to.

We can fabricate custom flashing for chimneys, walls, roof transitions, and more. If your situation calls for something non-standard - an unusual angle, a specific profile, a tricky material match - that's where in-house fabrication really matters. No waiting on special orders. No compromising with something close enough.

The difference between flashing that holds up for years and flashing that fails early usually comes down to fit. Tight seams, proper bends, material that's right for the application. We take that seriously at every step, from the shop bench to the finished install.